Did a little work on the Blazer today.

[Darrin]

http://www.boomspeed.com/bofh1968/blazer/1.jpg
http://www.boomspeed.com/bofh1968/blazer/2.jpg

That little rust spot has been bugging the hell out me to the point of me not waxing that side.

http://www.boomspeed.com/bofh1968/blazer/3.jpg

Took the grinder to it.

http://www.boomspeed.com/bofh1968/blazer/4.jpg

Add in a little JB Cold Weld liquid steel as filler...

http://www.boomspeed.com/bofh1968/blazer/5.jpg

Throw on some primer.

http://www.boomspeed.com/bofh1968/blazer/7.jpg

And a little rattle can paint that was as close a match as I could find. I had to take a little drive into town before I could snap a final picture, so it got all dirty. I'm going to let it sit overnight and wash it then buff it out tomorrow. I'll then throw on a coat of wax to the whole side and take another picture.

[Zirax]

Given the state of your truck i'm amazed you are worried by that little speck :D Which motor is this? You seem to have loads

[Darrin]

It's my little Chevy S-10 Blazer. I've only got the truck, the Blazer and my wife's Neon now. The truck is too far gone to even think about, but the Blazer is worth salvaging.

http://www.boomspeed.com/bofh1968/blazer/blazer_front.jpg
http://www.boomspeed.com/bofh1968/blazer/blazer_side.jpg

[Jonny69]

It's painful to read this thread, I hate rust removal :D

[Darrin]

Heh, seen my truck lately? On that it's not considered rust removal as much as it is rust replacement!! I mean, it's missing a 1 foot by 2 foot section of the rear of the driver's side at the back!! The whole area from the rear wheel to the bumper a foot up from the bottom just isn't there anymore...

http://www.boomspeed.com/bofh1968/chevy/rustyoops1.jpg
http://www.boomspeed.com/bofh1968/chevy/rustyoops2.jpg