|
19-02-2007, 18:21 | #1 |
Screaming Orgasm
Join Date: Jul 2006
Location: Newbury
Posts: 15,194
|
PC surgery might be needed
One of my PCs is making a horrible noise and I've got a sinking feeling that it's the fan on the Northbridge or PSU. I hope not, but I'd better be prepared if it is.
If it's the PSU, I don't fancy opening the PSU to fix it. I don't like playing in PSUs with scary big capacitors ready to bite me, and not being able to see where errant fingers are heading, and this PSU is extra small, which just magnifies the problem. If it's the Northbridge, that fan is almost completely inaccessible - clearences are so tight that you literally have to empty the case bar the CPU, motherboard and RAM. If I get it all out, I'm pretty certain I won't be able to get it all back in (in particular the CPU heatsink). So, assuming I can eliminate system and CPU fans (already done two, two to go), would anyone be willing to help? It's an SFF system (not a Shuttle though), but that still doesn't make it easy to hoik around, though I can probably get it to London without much bother. Any ideas gratefully accepted. |
19-02-2007, 20:36 | #2 |
Screaming Orgasm
Join Date: Jul 2006
Location: Newbury
Posts: 15,194
|
I'd do it myself save for the fact that heatsinks and PSUs scare me.
I'm about to build a C2D system too - and I'm going to try and do that one myself. |
20-02-2007, 00:49 | #3 |
Stan, Stan the FLASHER MAN!
Join Date: Jul 2006
Location: In bed with your sister
Posts: 5,483
|
I've had a PSU apart to replace a fan before but that was a standard ATX PSU. I can imagine a smaller PSU would be difficult - especially with restricted vision.
Northbridge fans are fiddly buggers too. I wish you luck Mark. Stan
__________________
Just because I have a short attention span doesn't mean I... |
20-02-2007, 11:03 | #4 |
Baby Bore
Join Date: Jun 2006
Location: Svalbard
Posts: 9,770
|
I ran my old Abit board without a Northbridge fan for a while, as long as the sink is good and you can get a small ammout of airflow to it it should be OK, it never crashed on me
MB |
20-02-2007, 14:37 | #5 |
Screaming Orgasm
Join Date: Jul 2006
Location: Newbury
Posts: 15,194
|
Airflow. Not much. Heatsink. Tiny. If it is the Northbridge fan, it'll need fixing ASAP.
|
20-02-2007, 17:04 | #6 |
I'm going for a scuttle...
Join Date: Jul 2006
Posts: 2,021
|
I would offer to help but I am prohibitively far away
|
21-02-2007, 12:37 | #7 |
HOMO-Sapien
Join Date: Jun 2006
Location: Chelmsford
Posts: 6,692
|
Are you Oc'ing Mark?
If not you may get away with passively cooling the NB as cooling blocks are dirt cheap but as you say this might not be easy. You need specialist equipment to ensure the PSU is safe to work on... They are dangerous even when switched off You could take out the PSU, turn it on outside the case if you can't hear where the noise is coming from.
__________________
I just got lost in thought.. It was very unfamiliar territory. Techie Talk | My gaming Blog | PC spec | The Admirals log |
21-02-2007, 16:29 | #8 |
I'm going for a scuttle...
Join Date: Jul 2006
Posts: 2,021
|
A pair of rubber gloves and a screwdriver is adequate
|
21-02-2007, 16:48 | #9 |
HOMO-Sapien
Join Date: Jun 2006
Location: Chelmsford
Posts: 6,692
|
I've heard about you and rubbers
__________________
I just got lost in thought.. It was very unfamiliar territory. Techie Talk | My gaming Blog | PC spec | The Admirals log |
21-02-2007, 14:21 | #10 |
Screaming Orgasm
Join Date: Jul 2006
Location: Newbury
Posts: 15,194
|
I'll be able to figure it out when it gets consistant enough that I can move the system out of it's current location and set it up on a desk. I can then eliminate most of the fans straight away.
My laptop cooler also has the same problem (noise), but I don't have screwdrivers small enough to open the sod up. Whoever thought of putting glasses-sized screws in a laptop cooler should be shot. |