Building a hot vintage engine with Jonny69

Jonny69 · 13-07-2007, 10:03

After a quick cleanup I can see that the surface of the block is good, the valve seats are all in good condition despite being used with unleaded fuel and the pistons are in good condition. There was hardly any carbon in there at all and the bores are in very good condition. All good news.

Final job was to flip it upside down and strip the block bare. Took the sump off, removed the flywheel and timing cover and started scraping all the old gaskets off. I'll be taking the cam, crank and pistons out next so they don't get contaminated with grinding paste or any of the muck when I start relieving the bore edges, then it's out with the power tools to do the fun bit. Mwahahahahah!!!!!

13-07-2007, 10:03	#11
Jonny69 Noob Join Date: Oct 2006 Location: Socialist Republik of Kent Posts: 5,032	After a quick cleanup I can see that the surface of the block is good, the valve seats are all in good condition despite being used with unleaded fuel and the pistons are in good condition. There was hardly any carbon in there at all and the bores are in very good condition. All good news. Final job was to flip it upside down and strip the block bare. Took the sump off, removed the flywheel and timing cover and started scraping all the old gaskets off. I'll be taking the cam, crank and pistons out next so they don't get contaminated with grinding paste or any of the muck when I start relieving the bore edges, then it's out with the power tools to do the fun bit. Mwahahahahah!!!!! __________________